Barracuda Networks 4 Especificaciones descargar pdf (Pagina 18)

Barracuda Web Filter Release 3.3

18 Chapter 2: Installation and Configuration

Installing and configuring the Barracuda Web Filter

These are the general steps to set up your Barracuda Web Filter. For more detailed instructions for

each step, see the following reference pages.

Step 1. Verify that you have the necessary equipment on page 18

Step 2. Install the Barracuda Web Filter on page 18

Step 3. Configure the Barracuda Web Filter IP and network settings on page 19

Step 4. Configure your corporate firewall on page 20

Step 5. Configure the Barracuda Web Filter on page 20

Step 6. Update the Barracuda Web Filter firmware on page 21

Step 7. Verify your subscription status on page 22

Step 8. Update the definitions on page 23

Step 9. Integrate the Barracuda Web Filter into your network on page 23

Step 10. Test and adjust the Barracuda Web Filter on page 24

Step 1. Verify that you have the necessary equipment

Before installing your Barracuda Web Filter, make sure you have the following equipment:

• Barracuda Web Filter (check that you have received the correct model)

• AC power cord

• Ethernet cables

• Mounting rails and screws (available for models 610, 810, and 910 only)

• VGA monitor (recommended)

• PS2 keyboard (recommended)

Step 2. Install the Barracuda Web Filter

To physically install the Barracuda Web Filter:

1. Fasten the Barracuda Web Filter to a standard 19-inch rack or other stable location.

CAUTION!

Do not block the cooling vents located on the front and rear of the unit.

2. Connect a CAT5 Ethernet cable from your network switch to the LAN port on the front of your

Barracuda Web Filter, as shown in the following figure.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 91 92

Sin comentarios

Barracuda Networks 4 Especificaciones Pagina 18