Barracuda Networks Firewall X100 Guía de usuario descargar pdf (Pagina 102)

Step 2. Configure Phase 2

To configure Phase 2:

In the left menu, right-click the entry (that you might have renamed to e.g. ) and select .Gateway Phase 1 New Phase 2

If you want to rename the entry that was created as a child of the entry, right-click it and select . For example,Tunnel Gateway Rename

you can rename it as .Phase 2

Click the entry and then click the tab.Tunnel IPSec

In the section, select as the .Addresses Subnet address Address type

In the remaining fields of the section, enter the network settings that were configured for the VPN service.Addresses

In the section, select the settings that are used by the VPN service.ESP

Step 3. Disable Mode Config

To disable the Mode Config:

Go tab , and verify that that the check box is cleared. Mode Config is ato Gateway > Advanced > Advanced features Mode Config

feature of certain routers to remotely configure the client's IP , which is not required in this setup.addressing

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 141 142

Sin comentarios

Barracuda Networks Firewall X100 Guía de usuario Pagina 102